Zap 8825-3-HPB Series-3 Super-Drive Industrial Duty DC Op

• Motor and controller: Continuous duty rated DC Motor with controller producing a powerful soft start/soft stop output of 2000 Newtons of force to drive commercial sectional doors while reducing mechanical impacts that cause premature wear of door components
• NEMA 4X rated controller case: ZAP Controllers and push buttons are NEMA 4X compliant as a standard
• Wiring type: C2 (factory default) B2 failsafe is standard with the addition of approved photo eye.
• Radio control and external receiver terminals: Terminal strip provided inside the controller to provide quick convenient connections for adding external radio control receivers from any desired manufacturer

Zap Battery Backup 8030/8830

• 8830 Battery Back up systems allows operation of the operator during power outages.

Micanan Overload Reset 1-Phase 5 Amps

Micanan Overload Reset 1-Phase 6 Amps

Micanan Overload Reset 1-Phase 7 Amps

Polyester Lifting Sling Type 3 Eye / Eye 3" x 8'

• 2-ply
• Minimum tensile strength of 9800 lbs per inch of width

Whiting Dual-Spring Shaft 84" for Whiting Roll-Up Doors

• Constructed of 1" outside diameter heavy-duty steel tubing
• Holes pre-drilled
• Cross Reference: For Whiting # 2376 balancer

Doorlec Electric Motor 1/3HP 208/480/575V 3PH DC321

Doorlec Electric Motor TEFC 1/3 HP 115/230V DC301

Steel Faced Laminated Bumper Black 12" x 14" 5 1/4" Projection Horizontal Installation

• Used on docks where excessive friction from up and down trailer movement occurs (yard jockeys air ride trailers etc.).
• Can be used in material handling application where medium to heavy dock protection is required
• “Gliding” heavy-duty steel face is 3/8” thick and independently anchored with elongated holes to face of bumper allowing bumper to compress AND offer high surface abrasion resistance
• Rubber pads laminated between steel angles and secured with 3/4” rods
• Bumper is fastened to dock surface with 3/8” steel angles and/or flat plates depending on the model chosen.
• Wall mounting hole size is 7/8” diameter.
• 12" x 14"