Molded Rubber Bumper Black 24" L x 10" W 4" Projection 2-Hole Sold Individually

• Manufactured from reinforced prime rubber
• Rectangular horizontal mount
• Ideal for light traffic loading docks.
• Perfect protection for in-plant wall protection from forklifts and other material handling vehicles molded bumpers will not warp rust rot or harden.
• Bumper comes with 2 pre-drilled countersunk mounting holes drilled to accept 3/4" anchor bolts
• 24" L x 10" W 4" Projection

Micanan Brake Assembly for PRO-TB/APTB with 110V Solenoid Inside - Old Model

Limit Switch DPDT 15A 125/250VAC (K23-2015) *** No Longer Available

Capacitor Motor Start 53 uF - 64 uF 220V *** No Longer Available

Doorlec Electric Motor TEFC 1.5 HP 115/230V 1P DC203C

• General purpose - Frame 56C
• 1725 RPM for worm-gear reducer models TEFC type

Whiting Dual-Spring Shaft 87" for Whiting Roll-Up Doors

• Constructed of 1" outside diameter heavy-duty steel tubing
• Holes pre-drilled
• Cross Reference: For Whiting # 2376 balancer

Micanan 3/4HP 115V 1P Hoist Operator NM ECB No Eyes Right Hand

• Continuous duty belt drive jackshaft operator with emergency chain hoist
• Full function Smart 10.0 Logic control board featuring on-board receiver with antenna
• Solenoid brake OPTIONAL
• Non-monitored board NO photoeyes

Micanan 3/4HP 115V 1P Hoist Operator NM ECB No Eyes Left Hand

• Continuous duty belt drive jackshaft operator with emergency chain hoist
• Full function Smart 10.0 Logic control board featuring on-board receiver with antenna
• Solenoid brake OPTIONAL
• Non-monitored board NO photoeyes

Cable Tie KSPEC 40 LB Black 14" Nylon 1000/pkg

• Length: 14" Width: 3.6MM (0.140")
• Low insertion and pull through force
• Advanced pawl and teeth design
• Angled tail provides quicker initial insertion alignment
• Tail finger grips allow easier handling and tightening
• Rounded edges provide added safety and eliminate insulation damage

Laminated Bumper Standard Black 12" x 24" 9" Projection Horizontal Installation

• For use in low to medium traffic loading docks in factories and warehouses.
• Can be used as rub rails at the sides of truck wells
• Fabric reinforced rubber pads cut from recycled truck tires.
• Rubber pads laminated between steel angles and secured with 3/4” rods
• Bumper is fastened to dock surface with 3/8” steel angles and/or flat plates depending on the model chosen.
• Wall mounting hole size is 7/8” diameter.
• 12" x 24"