Adjustable Regulated Power Supply with Optional BBU 6-24VDC 1AMP

• 3 preset voltages: 6 12 and 24 VDC
• Full adjustment from 2 to 24 VDC if required
• Requires AC transformer for input power (minimum 14 VAC for 12 VDC output 26 VAC for 24 VDC output cannot be connected directly to 120 VAC)
• Maximum 1 amp. Output at 70 deg. F and free air
• Ripple: Minimum load: 0.007vrms Half load: 0.028vrms Maximum load: 0.057vrms
• Regulation: 97.5%
• Fuse protected
• Built-in GELL CELL battery charger
• Automatic switchover to standby battery in case of AC power failure
• Battery leads (10" 254mm) complete with quick connectors
• Battery backup optional available separately
• Ease of installation with supplied adhesive mounting tape •Dimensions: Length: 3.19" (81mm) Width: 2.50" (64mm) Height: 1.38" (35mm)

Overhead Logic Board for RSX 1/2HP 1PH

• Fits OPRSXH75015BR

Truck Door Center Hinge Black E-coat finish for Todco Roll-Up Doors

• Steel construction Black E-coat finish

Todco Side Seal 80" long Lip ** Special Order Quote Only

• Special Order item. Must be quoted each time
• Fits Fleetstar Door

Doorlec Industrial Jackshaft Op. Explosion Proof 3/4 HP 115V-1Ph

• Equipped with: 3-btn control Adjustable Automatic Friction Clutch Emergency Chain Hoist and Heavy-Duty Solenoid Brake.
• Explosion proof EEMAC 7/9

Doorlec Ind Jackshaft Op. Watertight ECB 3/4 HP 230V-1Ph

• Heavy-Duty Industrial Operator with Waterproof Mod. for Sectional or Rolling Steel Doors
• DC-2000 logic with adjustable Timer-To-Close Delay On Reverse and Traffic Light Control (monitored board optional)
• Solenoid Brake prevents coasting and secures the door when closed
• TEFC (sealed) continuous duty electric motor with overload protection
• Automatic Friction Clutch protects the door and operator
• Self-aligning Heavy Duty sealed Pillow Block bearings on all shafts for high cycle applications
• #50 drive chain 5L350 v-belt
• Universal design allows installation of operator on either side of the door
• Floor Level Disconnect and Manual Chain hoist in case of power failure
• Nema4x Open/Stop/Close Wall control included
• Operating speed approx 12" per second
• Includes 1" chain spreader Part # 50535
• 2 year Warranty

Doorlec 1 HP 575V 3PH Jackshaft Operator

• Model LJH lasts an average of 10 million cycles
• Available with â…“ HP to 1 HP single-phase or three-phase motor and is equipped with self-adjusting solenoid brake
• LJH installation is universal regardless of side (left or right)
• Speed is approximately 1.4 feet per second or about 0.3 meters per second
• Comes equipped with a manual chain hoist

Doorlec Solenoid-Brake Lever Upper

• Fits model LJH

Lynx Bearing 1" *** Replaced by HW-BRG-1

• 2 in total on a MCJH

LiftMaster Control Board for RSL12V / RSW12V ** USE K001A6426-2