Micanan 1/2HP 575V 3P Jackshaft Monitored ECB N1 Eyes Right Hand

• On board receiver with antenna
• Continuous duty industrial motor with overload protection
• Heavy duty 5L V-belt
• Adjustable friction clutch
• Solenoid brake (optional PRO-JB) recommended for large doors
• 3/4" permanently lubricated & sealed precision ball bearings on pulley shaft
• Emergency disconnect with electrical cut-out switch for manual operation
• Three button open-close-stop control station Nema-1
• #41 roller chain & sprockets on all internal drives
• #50 roller chain and sprockets on final drive
• 1" permanently lubricated & sealed ball bearings on final drive shaft
• External radio control terminal strip

Doorlec Reversing Arm Spring

Doorlec Brake Release Cable

• Used on GH

Doorlec Electric Motor 1-1/2 HP 600V 3PH DC223C

Doorlec Electric Motor 1-1/2 HP 480V 3PH DC223C

Molded Rubber Bumper Black 13" L x 10" W 4" Projection 2-Hole Tapered Sides Sold Individually

• Manufactured from reinforced prime rubber
• Rectangular horizontal mount
• 4-1/2" depth
• Ideal for light traffic loading docks.
• Molded bumpers are molded in one piece and will not warp rust rot or harden.
• Perfect protection for in-plant wall protection from forklifts and other material handling vehicles. and will not warp rust rot or harden.
• Bumper comes with 2 pre-drilled countersunk mounting holes drilled to accept 3/4" anchor bolts
• 13" L x 10" W 4" Projection
• Tapered sides 22 degee taper

Steel-Faced Laminated Bumper Black 6 3/4" Projection Vertical Installation 20" x 11" Sold Individually

• Used on docks where excessive friction from up and down trailer movement occurs (yard jockeys air ride trailers etc.).
• Can be used in material handling application where medium to heavy dock protection is required.
• 5/8" anchor bolts mounted through pre-drilled holes into dock or can be welded to curb angle.
• Steel face is 3/8" thick heavy duty high carbon steel that is mounted over a laminated dock bumper.
• Plate to be welded to 2 or 3 steel support brackets which are to extend back to the 3/4" supporting rods.
• Brackets to be punched with elongated holes to allow steel face to "float" upon impact.
• Size: 11" w x 20" h

EMX Vehicle Motion Detector Probe with 50ft Lead Wire

• The VMD202 Vehicle Motion Detector is the most advanced single-piece vehicle motion sensor on the market today.
• The probe and its electronics are housed in a slim design that is buried next to a driveway.
• The VMD202-R Sensitivity Remote Control (sold separately) makes installation and fine tuning simple
• Probe assembly and wire are water tight and direct burial compatible
• Harness is pre-wired onto lead wire for easy installation
• Settings are placed in a non-volatile memory in case of power failure
• Accepts wide range of power inputs from 9 – 41 VDC or 6 – 29 VAC
• Low current consumption of 250uA standby and 12mA activated
• Same as VMD202-5-50

Residential Side & Top PVC Weather-Strip with cap 8' Long - Brown (N)

• Brown rigid vinyl retainer with brown flexible vinyl seal.
• Dual fin vinyl.
• Comes with cap to hide screws.

Residential Side & Top PVC Weather-Strip with cap 12' Long - Brown (N)

• Brown rigid vinyl retainer with brown flexible vinyl seal.
• Dual fin vinyl.
• Comes with cap to hide screws.