Special Order Hydraulic Dock Leveler Custom Order

• Custom ordered to customer requirements

Doorlec Electric Motor TEFC 3/4HP 115/230V DC403

• ase mount

LiftMaster Expansion Board CSL24V

• This is a replacement CSL24V Expansion Board
• For use with various LiftMaster® Slide and Swing Gate Operators

RENO 11-Pin Amphenol Style Connector 12-24V Single Channel Loop Detector *** To Extent of Inventory

• The Model B is a full featured single channel dual output vehicle detector that incorporates the reliable vehicle detection technology found in all of Reno A & E s vehicle detectors.
• All detector functions and settings are configured by using a set of eight internal DIP switches and a front panel mounted pushbutton switch
• Dimensions: 11-Pin Models - 3.00 inches (7.62 cm) high x 1.75 inches (4.45 cm) wide x 4.30 inches (10.92 cm) deep

Linear 1-btn MegaCode Block Coded Transmitter 318 MHz

• Compatible with all Linear access receivers and controllers
• Superior transmission range
• Operate LED
• Visor clip included
• Sold in lots of 10
• Power: 9-volt battery
• Codes: Factory block coded in MegaCode format
• RF frequency: 318 MHz
• Dimensions: 2.2" W x 3.8" H x 0.9" D
• Same as: ACP00877

Doorlec Industrial Jackshaft Op. 1 HP 208V-3Ph

• Heavy-Duty Industrial Operator for Sectional or Rolling Steel Doors
• DC-2000 logic with adjustable Timer To Close Delay On Reverse and Traffic Light Control
• Solenoid Brake prevents coasting and secures the door when closed
• TEFC (sealed) continuous-duty electric motor with overload protection
• Automatic Friction Clutch protects the door and operator
• Self-aligning Heavy Duty sealed Pillow Block bearings on all shafts for high cycle applications
• #50 drive chain 5L350 v-belt
• Universal design allows installation of operator on either side of the door
• Floor Level Disconnect and Manual Chain hoist in case of power failure
• Operating speed approx 12" per second
• Includes 1" chain spreader Part # 50535
• 2 year Warranty

Doorlec Industrial Jackshaft Op. 1/2 HP 208V-3Ph

• Heavy-Duty Industrial Operator for Sectional or Rolling Steel Doors
• DC-2000 logic with adjustable Timer To Close Delay On Reverse and Traffic Light Control
• Solenoid Brake prevents coasting and secures the door when closed
• TEFC (sealed) continuous-duty electric motor with overload protection
• Automatic Friction Clutch protects the door and operator
• Self-aligning Heavy Duty sealed Pillow Block bearings on all shafts for high cycle applications
• #50 drive chain 5L350 v-belt
• Universal design allows installation of operator on either side of the door
• Floor Level Disconnect and Manual Chain hoist in case of power failure
• Operating speed approx 12" per second
• Includes 1" chain spreader Part # 50535
• 2 year Warranty

Doorlec Industrial Jackshaft Op. 3/4 HP 208V-3Ph

• Equipped with: 3-btn control Adjustable Automatic Friction Clutch Emergency Chain Hoist and Heavy-Duty Solenoid Brake.

Flanged Bearing 3/4" x 1-1/2" x 1/8"

Felco C7 Cable Cutter 3/16" Capacity

• Tool length: 8"
• Gives a clean cut without crushing thanks to the triangular cutting system.
• Blades and centre bolt in high-quality hardened steel for exceptional performance.
• Thumb catch designed for one-handed operation.
• Pressed steel handles with non-slip grips
• Maximum cutting diameter: 7mm / 0.28in